Counter and Indicators :- PRiCO

Download our Brochure For Technical Details

PRiCO

PRiCO (Programmble intelligent Counter)
PRiCO provides a very cost – effective and reliable solution to many complex counting requirement.
What sets PRiCO apart from the convention facet.

SPECIFICATIONS :

Counting modes

» Up counting

» Down counting

» Quadrature counting

» Bi-directional counting

Display

7-digit, seven segment LED display (10mm height)

» Counter/Totaliser/Batch: 7- digit display

» Rate : 5- digit display

» RPM : 6- digit display

Range

» Counter/Totaliser:Selectable least count 0.000001, 0.00001, 0.0001, 0.001, 0.01, 0.1, 1

» Rate: Rate per minute (RM) / Rate per hour (RH) user selectable. (minimum frequency for Rate mode is 10 Pulses/minute)

» RPM: 10 RPM to 360000 RPM

Set points

» 3 user programmable set points.

» SET1 , SET2 :Dedicated for COUNTER mode.

» SET3 : User programmable for any one of COUNTER / TOTALISER /BATCH / RPM.

Relay operating mode

» Relay ON mode

» Relay OFF mode

» Pulse time mode
a) Time pulse repeat mode
b) Auto-reset mode

Count inputs

» Voltage pulse : 8 to 30 V DC amplitude from proximity switch, encoder.

» Potential free contacts from limit switch, micro switch.

Input frequency

» 0 to 6 KHZ: In up / down mode

» 0 to 3 KHZ: In quadrature mode / bi-directional mode.

Sensor supply

» 12 V DC, 60mA (+/- 10 %)

Scale factor

» Programmable

» scale factor = X x 10^Y
X = From 0.000001 to 9.999999
Y = 0, 1, 2, -1, -2, -3, -4, -5

Reset input

» Manual / Front panel reset: with enable / disable facility

» Remote/ Back panel / Electrical reset: User selectable
( minimum time for remote reset is 10 ms. )

» Reset through programming mode: User selectable

Relay outputs

» Three Relays ( one relay for each set point )

» Relay1/ Relay2 for set1/set2 operation ( COUNTER )

» Relay3 for set3 ( COUNTER / TOTALISER / BATCH / RPM ) – Programmable

» Relay ratings: Rated for 5 Amp at 230 V AC

Memory retention

» Upto 10 years

Protection

» Parameters
a) Password protected
b) Hardware protected (Dip switch setting)

» Set points
a) Software protected (Through program configuration i.e. ‘SdF 3.’)

Supply

» 230 V AC (+/- 10%)

Mounting

» Panel mounting

Weight

» approximately 580 gms

Operating temperature

» 0° to 50° C

Relative humidity

» 10 – 95% non-condensing

Overall dimensions

» (All dimensions are in mm.)

OTHER COUNTERS :

Reset Counter

Totaliser Cum Rate Indicator

Speed Controller

Download our Brochure For Technical Details

download

PRODUCTS